Orion OREL Notice D'installation Et D'utilisation page 87

ORRS and ORRA receivers : Switch off the receiver
1
ORRD receiver : the receiver can remain powered up throughout the procedure
ORRS and ORRA receivers : install the jumpers
the settings.
ORRD receiver : set the microswitches
ORRS
2
30 31 32 33 34 35 36 37
V1 V2 V3
JP1
R1
R2
R13 R14
ORRS and ORRA receivers : Switch on the receiver
3
ORRD receiver : go to the next step
- V2
4
- The receiver waits for an identity code reception (pressure on a transmitter
function button) to auto-configure its relays.
Press
5
On/Off » button only (for R0 association), then release the buttons.
x = 1 to 12
Press on one transmitter button (anyone) and maintain button pressed to
associate transmitter with the receiver, until receiver LEDs
ORRA
6
V3 ORRS ORRD
The receiver has received the command to assign the buttons and identity code
of the transmitter to the function relays.
ORRS and ORRA receivers : switch off the receiver and remove the
7
and
ORRD receiver : set the
8
Repeat the association procedure for each receiver to be associated
Orion - 324501J
JP3
JP2
R3
R4
R15 R16
ORRA
ORRS ORRD
V3
and
then press the « On/Off » button (for the Rx association) or on the «
Bx
go off.
jumpers.
ORRA
JP1
JP2
V1 V2 V3
LEDs are blinking.
and microswitches to the «OFF» position
DE
and
and to the «ON» position
ORRD
JP3
EN FR
to configure
OFF ON
JP1
JP2
JP3
JP4
V1 V3 V2
V2 and
- 87 -