Charger Supports - Orion OREL Notice D'installation Et D'utilisation

6.2- Charger supports

IMPORTANT : The charger supports can only be used with the
Multifunction Orion transmitters (ORELxxxxx) equipped with
AAA accumulators.
DO NOT CHARGE THE BATTERIES.
Length of cable between voltage adapter and charger support
ORCL1 / vehicle plug
(12-24VDC > 9VDC)
delivered with 3 accus AAA
The fuse on ORCL1 (250V @ 2A) can be replaced by unscrewing the tip.
To recharge the Multifunction transmitter with accumulators :
1. Supply the charger support
2. if present, push on «On/Off» button to switch off the transmitter (red and
green indicator lights are OFF).
3. Place the transmitter on the charger support.
During the charging operation, the green indicator light on the transmitter (
on steady and the red indicator light shows the charge level (
Red indicator light flashing :
Red indicator light on steady : slow or up-keep charge (transmitter
Radio controls cannot be generated when the transmitter is charging.
FR
- 72 -
Material, housing color and tightness
Supply by vehicle connector
Supply by «European» or «UK» connector
Output voltage and current
Temperature ranges
ORCLU / EU, UK and US plugs
(230VAC > 9VDC)
delivered with 3 accus AAA
EN DE
Weight
fast charge
accumulator charge level is > or = 60%)
Charger support
ABS, Yellow, IP20
400 g.
12 to 20 VDC
230 VAC
9 VDC, 300 mA
Storage : - 30°C to + 70°C
Charging : 0°C to + 40°C
1,70 m approximately
) :
Orion - 324501J
(ORCL)
) comes