Orion OREL Notice D'installation Et D'utilisation page 83

- V2 and
4
- The receiver is waiting for an order from the transmitter to start the buttons / relay assignment
5
If the transmitter has a «On/Off» button, turn on the transmitter.
-
the receiver is waiting for a "button number and identity code" to "assign" them to its relay n°1
the receiver is waiting for a "button number and identity code" to "assign" them to its relay n°2
6
the receiver is waiting for a "button number and identity code" to "assign" them to its relay
V2
The last relay of the receiver has been assigned, the procedure is ended.
ORRS and ORRA receivers : Switch off the receiver
ORRD receiver : set the microswitch
(1) = Special case of ORRA receiver with number «X» > 9
In this case, the number of the relay to be programmed is given by the flashing indicator lights
V3
V2 and
V3 flashes 5 times: the receiver is on standby for a «button + identity code» assignment for its relay No. 15).
7
If other associations are required, repeat the procedure in step N°3
Once you have completed the associations :
8
ORRS and ORRA receivers : switch off the receiver and remove the jumper
ORRD receiver : set the microswitch
Orion - 324501J
ORRA
ORRS ORRD
V3 are ON steady.
- Press on and release any transmitter function button
ORRA goes OFF,
V3 ORRS ORRD
V2
- Press on transmitter button n°1 (i.e) within 6,5 seconds
- The receiver records the assignment : "button nb.1 + identity
code (xxxxxxxx)" / relay nb.1
V2
- Press on transmitter button n°2 (i.e) within 6,5 seconds
- The receiver records the assignment : "button nb.2 + identity
code (xxxxxxxx)" / relay nb.2
blinks X times
V2
- Press on transmitter button n°Y (i.e) within 6,5 seconds
- The receiver records the assignment : "button nb.Y + identity
code (xxxxxxxx)" / relay nb.X
ORRA
and blink in a alternative way then go OFF
V3 ORRS ORRD
ORRA
ORRS ORRD
V2 indicates the tens, and
the programming procedure starts
blinks 1 time
blinks 1 times
to the «ON» position
V3 the units (i.e. :
to the «OFF» position
DE
if no button is
pressed within 6,5s
the receiver selects
the relay n°2
if no button is
pressed within 6,5s
the receiver selects
the relay n°X
V2 flashes once and
EN FR
(1)
- 83 -