2- Association Bi-Control With 1 Relay - Orion OREL Notice D'installation Et D'utilisation

7.4.2- Association bi-control with 1 relay

It is possible to associate a button for closing a relay and a second button
for opening it. This association automatically sets the operating mode to
bistable.
► Repeat procedure 7.4.1 and in step 6 to set the relay 1 in bi-control
bistable mode :
-
the receiver is waiting for a "button number and identity code" to "assign" them to its relay n°1
-The receiver records the assignment : "button nb.1 and nb. 2 + ID code (xxxxxxxx)"
/ relay nb. X and configure the operating mode of this relay in bistable.
the receiver is waiting for a "button number and identity code" to "assign" them to its relay n°2
6
the receiver is waiting for a "button number and identity code" to "assign" them to its relay
V2
The last relay of the receiver has been assigned, the procedure is ended.
ORRS and ORRA receivers : Switch off the receiver
ORRD receiver : set the microswitch
(1) = Special case of ORRA receiver with number «X» > 9
In this case, the number of the relay to be programmed is given by the flashing indicator lights
V3
and
V2
flashes 5 times: the receiver is on standby for a «button + identity code» assignment for its relay No. 15).
V3
The closing of the relay will always be controlled by the button with the
smallest number.
For example, if parameter B3 and B5 are set on relay 2 in bi-control
bistable, then in operation, button B3 will command the closing of the relay
and button B5 will control its opening.
FR
- 84 -
- Press on and release any transmitter function button
ORRA goes OFF,
V3 ORRS ORRD
blinks 1 time
V2
- Press 2 buttons on the transmitter at the same time
(eg B1 and B2) within 6.5 seconds
blinks 1 times
V2
- Press on transmitter button n°2 (i.e) within 6,5 seconds
- The receiver records the assignment : "button nb.2 + identity
code (xxxxxxxx)" / relay nb.2
blinks X times
V2
- Press on transmitter button n°Y (i.e) within 6,5 seconds
- The receiver records the assignment : "button nb.Y + identity
code (xxxxxxxx)" / relay nb.X
ORRA
and blink in a alternative way then go OFF
V3 ORRS ORRD
ORRA
ORRS ORRD
indicates the tens, and
V2
EN DE
the programming procedure starts
to the «ON» position
the units (i.e. :
V3
if no button is
pressed within 6,5s
the receiver selects
the relay n°2
if no button is
pressed within 6,5s
the receiver selects
the relay n°X
flashes once and
V2
Orion - 324501J
(1)