Velleman PIR416 Mode D'emploi page 4

• Dam age caused by disregard of certain guidelines in t his m anual
is not covered by t he warrant y and t he dealer will not accept
responsibilit y for any ensuing defect s or problem s.
4 . I n st a lla t ion
Refer t o t he illust rat ions on page 2 of t his m anual.
The inst allat ion m ust be carried out by a qualified person.
1 . Choose a proper locat ion for t he sensor. Avoid places where
t em perat ure changes frequent ly, e. g. near air condit ioners or
heat ing devices. Also avoid m oving obst ruct ions or object s in t he
det ect ion field of t he sensor t o prevent unnecessary act ivat ion.
2 . The PI R sensor m ust be inst alled inside a hole which is m ax.
12 m m in diam et er. The cont roller can be installed on t he ot her
side of t he wall, inside a dropped ceiling or, behind a false wall.
Leave sufficient space ( at least 2 cm ) around t he cont roller for
vent ilat ion.
• The lead wires of t he sensor are ± 20 cm long. When m ount ing
N ot e s:
t he cont roller on t he ot her side of a wall, drill a hole of at least
• Make sure t he cont roller is accessible at all t im es when inst alling
12 m m for t he connect or and wires t o go t hrough.
inside a dropped ceiling or behind a false wall. However, it should
be sufficient ly prot ected t o avoid accident al t ouching!
3 . A 12 Vdc/ 2. 6 A power supply ( not incl. ) m ust be provided.
4 . Connect t he sensor t o t he cont roller [ 2 ] . The connect or fit s only
one way, do not force.
5 . Set t he DI P swit ches [ 3 ] :
light sensit ivit y
m ovem ent sensit ivit y
5" On- t im e
30" On t im e
1' On- t im e
3' On- t im e
5' On- t im e
8' On- t im e
N ot e : only t he highest select ed on- tim e will be applicable.
V. 04 – 17/ 10/ 2014
PI R4 1 6
ON
< 10 lx
low
5 seconds
30 seconds
1 m inut e
3 m inut es
5 m inut es
8 m inut es
4
OFF
always
high
-
-
-
-
-
-
© Vellem an nv