Rheem GEN20AD-E Guide D'utilisation page 17

General Set Up Screen
For general set up, press and hold the left arrow and right arrow
as outlined below.
NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was
also set at the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time.
To updated or change these settings, follow the steps below.
SET DATE
or
SET TIME
or
SET EXERCISE
CYCLE
EVENT
LOG
YEAR
FLASHING
or
HOURS
FLASHING
or
OFF OF OFF If set to OFF, display will read: EXERCISE CYCLE OFF
or or
DAY OF WEEK A A A A Y OF WEEK Y OF WE
FLASHING FLASHING FLASHING
or
Display will scroll last service code event, date, time, and
temperature of when the event occured.
IF DURING PROGRAMMING NO BUTTONS ARE PRESSED FOR 30 SECONDS,
THE CONTROL PANEL WILL AUTOMATICALLY EXIT THE PROGRAM MODE.
for 3 seconds. Follow the prompts
DAY##
MONTH
FLASHING
FLASHING
or
MIN AM/PM
FLASHING FLASHING
or
display display will wi rea re
MIN
HOURS HOURS HOU
FLASHING FLAS FLASHING
or
or
or
or r or
or
AM/PM
FLASHING
or
or
17