Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INITIAL OPERATION
Protect the
!
WARNING
measuring tool
against moisture and direct
sun light.
Do not subject the measuring
tool to extreme temperatures
or variations in temperature.
As an example, do not leave it
in vehicles for longer periods.
In case of large variations
in temperature, allow the
measuring tool to adjust to
the ambient temperature
before putting it into
operation. In case of extreme
temperatures or variations in
temperature, the accuracy of the
measuring tool can be impaired.
Avoid heavy impact to or
falling down of the measuring
tool. After severe exterior
effects to the measuring tool,
it is recommended to carry
out an accuracy check (see
"Accuracy Check of the Distance
Measurement", page 17) each
time before continuing to work.
Switching On and Off
For switching on the measuring
tool, the following possibilities
are given:
– Pressing the On/Off button 4:
The measuring tool is switched
on and is in length measurement
Operation
mode. The laser is not activated.
– Pressing the measuring button
2: Measuring tool and laser are
switched on. The measuring tool
is in length measurement mode.
Do not point the laser beam
!
WARNING
not look into the laser beam
yourself, not even from a long
distance.
To switch off the measuring
tool, press the On/Off button 4
for a few seconds.
When no button on the
measuring tool is pressed
for approx. 5 minutes, the
measuring tool automatically
switches off to save the
batteries.
MEASURING PROCEDURE
After switching on by pressing
the measuring button 2, the
measuring tool is always in
length measurement mode.
Other measuring modes can
be switched to by pressing the
respective function/mode button
(see "Measuring Functions",
page 13).
After switching on, the rear edge
of the measuring tool is preset
as the reference point for the
measurement. By pressing the
reference level button 6, the
-11-
at persons or
animals and do
Publicité
Table des Matières
