Initial Operation - Bosch PLL 5 Notice Originale

OBJ_BUCH-311-005.book Page 26 Wednesday, July 14, 2010 11:45 AM
26 | English
Operation

Initial Operation

Protect the measuring tool against moisture and
direct sun light.
Do not subject the measuring tool to extreme tem-
peratures or variations in temperature. As an ex-
ample, do not leave it in vehicles for longer periods.
In case of large variations in temperature, allow the
measuring tool to adjust to the ambient tempera-
ture before putting it into operation.
Avoid heavy impact to or falling down of the meas-
uring tool. Damage to the measuring tool can impair
its accuracy. After heavy impact or shock, compare
the laser line with a known horizontal or vertical ref-
erence line.
Switching On and Off
To switch on the measuring tool, push the On/Off
switch 15. Immediately after switching on, the measur-
ing tool sends a laser beam out of the exit opening 9.
Do not point the laser beam at persons or animals
and do not look into the laser beam yourself, not
even from a large distance.
To switch off the measuring tool, push the On/Off
switch 15 again.
Do not leave the switched on measuring tool unat-
tended and switch the measuring tool off after
use. Other persons could be blinded by the laser
beam.
1 609 929 W57 | (14.7.10) Bosch Power Tools