Publicité
Alimentation:
Consommation:
Semi-conducteurs:
Dimensions:
Largeur;
Hauteur;
Profondeur;
Poids:
Bande:
Vitesse de la bande:
Pieurage et scintillement:
Bande normale;
For a complete description of the operation of
this unit, please refer to the operation manual.
Prior to the disassembly, be sure to remove the AC supply
cord from a wall outlet and the input/output plugs from the
rear of the unit. Take out a cassette tape, if loaded in the
cassette compartment.
REMOVAL OF CABINET
n
From the cabinet, remove four screws two each at its right
and left sides, and one screw at its rear surface. Then take
the cabinet off.
Note:
The main chassis (bottom board and back panel) are
hinged.
ing toward @ from the left and right sides.
. REMOVAL OF MECHANISM BLOCK
(See Figures 2-2 and 2-3)
Note:
Be sure to open the cassette holder before disassembling
the mechanism block.
block.
Then separate the mechanism block from the unit.
. REMOVAL OF METER P.W. BOARD
(See Figure 3-l)
Push outward two tabs on the meter P.W. board holder,
and remove the meter P.W. board.
. REMOVAL OF FRONT PANEL
(See Figures 3-2 and 12-l)
board.
Then the front panel can be separated from the unit.
CA 1 lOV/22OV/24OV, 50/60Hz
12 w
5
Cl (circuit int8gr6)
9 transistors
8 diodes
390mm
216mm
Bande cassette compacte
(DIN 45 500)
40 B 12 500Hz
(DIN 45 500)
50
Die Bedienungsweise dieses Gerltes ist in der
Bedienungsanleitung ausfiihrlich beschrieben.
(See Figure 2-l)
(See Figure 2-2)
Bande MAXELL UDXLII; 40 B 13 OOOHz (DIN 45 500)
Bande mbtallique TDK;
Rapport signal/bruit (Bande MAXELL UDXLII):
RB Dolby coup6;
RB Dolby allum6;
Microphones;
Entree de ligne;
Niveau de sortie et impedance de charge:
Casque;
Sortie de ligne;
Sortie DIN;
L e s sp6cifications peuvent &re sujettes SI m o d i f i c a t i o n s sans
Pour une description compl6te du fonctionne-
d' emploi.
Figure 2-2
Figure 2-3
50 i 12
40
50 i 13.000Hz + 3dB
52dB
62dB (?I plus de 5 kHz)
50mV (50 kohms)
550mV (" 0" dB), 50 kohms
550mV ("0" dB), 50 kohms
Abbildung 2-2
Abbildung 2-3
Publicité
