Assembly - Mantis 811103 Mode D'emploi

6. Assembly

GB
Checking all the Parts are
Included
The box contains the following
parts:
Cordless Reel Mower
.
1 Battery
.
1 upper section of the guide
.
handle
1 middle section of the guide
.
handle
2 lower section of the guide
.
handle
Assembly parts for the guide
.
handle in a plastic bag
1 Charger (24 Volt)
.
1 thickness gauge
.
Operating instructions
.
Fitting the Guide Handle
Insert the lower section of the
guiding handle (Fig. A, Pos. 1)
through the opening (Fig. B, Pos.
B1). The arches of the lower
section of the guiding handle
must point to the center of the
piece of equipment. The lower
section of the guiding handle is
to be positioned over the handle
The packaging
material is made of
recyclable materials.
Dispose of packaging
materials in
accordance with regulations.
12
bolts (Fig. B / C, Pos. 7) with the
boreholes (Fig. C, Pos. 6).
Repeat this on the opposite side
with the second lower section of
the guiding handle.
Warning! Do not apply
A
force during assembly.
Insert the beam screw (Fig. A,
Pos. 5) through the borehole of
the cable clip (Fig. A, Pos. 8).
Fit the middle section of the
guiding handle (Fig. A, Pos. 2)
together with both lower sections
of the guiding handle as
demonstrated in Fig. A. Where
the boreholes align, insert the
beam screw with the cable clip
through the boreholes, position
the washer on to the beam
screw (Fig. A, Pos. 13) and then
screw the parts together hand
tight with the beam screw
handle (Fig. A, Pos. 4).
Take the upper section of the
guiding handle and place this
part as demonstrated in Fig. A
Electrical appliances are not to
be disposed of in the normal
household waste, they must be
professionally disposed of.
together with the middle section
of the guiding handle. Where
the boreholes align, insert the
beam screw with the cable clip
through the boreholes, position
the washer on to the beam
screw (Fig. A, Pos. 13) and then
screw the parts together hand
tight with the beam screw
handle (Fig. A, Pos. 4).
Fasten the cable by pushing the
clamp on to the lower part of the
bar from outside (Fig. A,
Pos. 25).
Warning! Ensure that the
A
cable is not squeezed