Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Before starting the machine remove any adjusting wrenches and
screwdrivers
•
Fix the workpiece with the right tool
•
Machine only stock which is chucked securely on the machine, always
check before switching the machine on
•
Provide workpiece with centre holes before clamping between centres
•
Before start working remove any nails and other foreign bodies from the
workpiece
•
Keep any machine that is not being used out of reach of children
•
Never grab into the running machine!
•
Remove chips and workpiece parts only if the machine is standing still!
•
Never stop workpieces with the hand during run out!
•
Never take measurements on a rotating workpiece!
13.3 Remaining risk factors
It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest
attention is required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
Risk of injury to the hands / fingers by the rotating workpioece during operation.
Risk of injury due to sharp edges of the workpiece, especially in non-fixed with a
suitable tool / device workpiece.
Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety
regulations must be observed with regard to clothing.
Risk of injury due to contacting with live electrical components.
Risk of injury due to dust emissions, treated with harmful agents workpieces
Risk of injury to the eye by flying debris, even with safety goggles.
Risk of injury to the hearing by prolonged labor without hearing protection.
Risk of injury due to kickback:
Kickback is a sudden reaction. This causes the ejection of the tool to the direction of
the operator.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
W A R N I N G
SAFETY
24
D 510F
Publicité
Table des Matières
Dépannage
