Initial Operation; Maintenance Work; Technical Data - LiftMaster Chamberlain SLY250 Installation

INITIAL OPERATION

Check gate functionality manually when the drive has been
disengaged. Electrical operation is only possible with acontrol unit.
Electrical connections: See control unit instructions.
Always ensure that the mechanical and electrical safety requirements
relevant to the given system are complied with.

MAINTENANCE WORK

The drive mechanics are maintenance-free. Check at regular
intervals (monthly) that the gate hardware and the drive are all firmly
in place. Disengage the drive and check gate functionality. Only an
easy-running gate will work well with a drive. A drive is no substitute
for a poorly functioning gate.
A sliding gate can also be secured by implementing on-site
measures (fence, wall, etc.). See fig. 11.
D e c l a r a t i o n o f C o n f o r m i t y
Automatic Gate Opener Models SLY250XXX are in conformity to the applicable
sections of StandardsEN300220-3 • EN55014 • EN61000-3 • EN60555, EN60335-1 • ETS
300 683 • EN60335-1: 2002 • EN60335-2-103: 2003 • EN55014-1: 2000 + A1 + A2 •
EN55014-2: 2001 • EN61000-3-2: 2000 • EN61000-3-3: 1995 + A1 • EN 301 489-3,
V1.3.1 • EN 300 220-3 V1.1.1 • EN13241-1
per the provisions & all amendments
of the EU Directives .............................................2006/95/EC, 2004/108/EC, 1999/5/EG
D e c l a r a t i o n o f I n c o r p o r a t i o n
Automatic Gate Opener Models , when installed and maintained according to all the
Manufacturer's instructions in combination with a Gate, which has also been installed and
maintained according to all the Manufacturer's instructions, meets the provisions of EU
Directive 98/38EC and all amendments.
I, the undersigned, hereby declare that the equipment
specified above and any accessory listed in the manual
Harry Naumann
Manager, Regulatory Affairs
Chamberlain GmbH
D-66793 Saarwellinge
July, 2008

TECHNICAL DATA

Voltage IN
Frequency
Nominal Power
Max. Power
Current rated
Torque
Capacitor
Motor Speed
Working Temperatur
Range
Protection Class
conforms to the above Directives and Standard
Harry Naumann Dipl.Ing.(FH)
Manager, Regulatory Affairs
230Volt
50Hz
120W
130
1A
6Nm
8μF
1380
-25 O C - +55 O C
IP44
s.