Troubleshooting - Hoover UH71120 Manuel Du Propriétaire

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below.
This product contains no serviceable parts.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at
1-800-944-9200 prior to continuing use.
PROBLEM
Vacuum won't
run
System Check
Indicator has
turned red
or
Vacuum won't
pick up
or
Low suction
Dust escaping
from vacuum
Vacuum is
difficult to push
or won't move
forward
Smoky/burning
smell detected

5. TROUBLESHOOTING

WARNING
!
To reduce risk of personal injury - Unplug before cleaning or servicing.
POSSIBLE CAUSE
1. Power cord not firmly plugged
into outlet.
2. Blown fuse or tripped breaker.
3. Thermal Protector activated.
1. Rinsable Filter and/or Exhaust Filter
is dirty.
2. Dirt cup full and/ or clogged.
3. Broken or worn belt.
4. Brushroll and/ or Hose
clogged.
5. Carpet height setting is
incorrect.
1. Dirt cup full.
2. Dirt cup not installed correctly.
3. Hose not installed correctly.
4. Rinsable Filter and/or Exhaust Filter
not installed completely.
1. Carpet height setting is
incorrect.
1. Belt broken or stretched.
2. Brushroll is clogged.
!
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
3. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Clean Rinsable Filter and/or Exhaust Filter is dirty. -
Reference Pg. 9 & 10.
2. Empty dirt cup - Pg. 9.
3. Replace belt - Pg.12.
4. Check Hose - Pg. 13. Check Brushroll - Pg. 11.
5. Set Carpet Height Adjustment to appropriate setting
for carpet being cleaned - Pg.6.
1. Empty dirt cup - Pg. 9.
2. Review Dirt Cup removal & replacement -
Pg. 9.
3. Review Hose installation - Pg. 7.
4. Review Filter Removal and Cleaning - Pg.
9 and 10.
1. Set Carpet Height Adjustment knob to
appropriate setting for carpet being cleaned
- Pg. 6.
1. Replace brushroll belt - Pg. 12.
2. Clear/ remove debris from brushroll - Pg. 11.
Actual model may vary from images shown.
13