Replacing The Spark Plug; Idle Speed Adjustment - Toro 51948 Manuel De L'opérateur

Replacing the Spark Plug

See Figure 10.
All model numbers included in this manual use a Champion
RCJ4 or RCJ6Y spark plug. Use an exact replacement and
replace annually.
1. Remove the spark plug boot.
2. Loosen the spark plug by turning it counterclockwise
with a socket.
3. Remove the spark plug.
4. Inspect the new spark plug. The spark plug must
be properly gapped and free of deposits in order to
ensure proper engine operation. The correct gap is
approximately 0.025 in. (0.64 mm). To widen gap, if
necessary, carefully bend the ground (top) electrode.
To lessen gap, gently tap ground electrode on a hard
surface.
5. Hand thread the new spark plug, turning it clockwise.
6. Tighten with a socket. [torque to 177 in.lb. (20 Nm)
minimum, 221 in.lb. (24.97 Nm) maximum. Do not
overtighten].
NOTICE:
Be careful not to cross-thread the spark plug. Cross-
threading will seriously damage the product.
Spark Plug Boot
Maintenance

Idle Speed Adjustment

See Figure 11.
WARNING:
The blade/cutting head will move when
adjusting the idle speed. Wear all protective
clothing and keep all bystanders, children,
and pets at least 50 ft (15 m) away. Make
adjustments with the unit supported by hand
so that the blade/cutting head does not contact
the ground or any object. Keep all parts of your
body away from the blade/cutting head and
muffler. Failure to follow these instructions
could result in serious personal injury.
If the cutting attachment turns at idle, the idle speed screw
needs adjusting on the engine. Turn the idle speed screw
counterclockwise to reduce the idle RPM and stop the cut-
ting attachment movement. If the cutting attachment still
moves at idle speed, contact a service dealer for adjustment
and discontinue use until the repair is made.
WARNING:
The cutting attachment should never turn at idle.
Turn the idle speed screw counterclockwise
to reduce the idle RPM and stop the cutting
attachment, or contact a service dealer for
adjustment and discontinue use until the repair
is made. Serious personal injury can result from
the cutting attachment turning at idle.
Spark
Idle Speed
Plug
Screw
Figure 10
Figure 11
17