Using The Battery; Checking And Switching On The Battery; Inserting The Battery In The Drivepack - FAZUA RIDE 50 TRAIL Notice Originale

2 7 USING THE BAT TERY

27.1 Checking and switching on the BATTERY

Risk of explosion and fire!
A damaged or dirty battery may explode and/or cause a fire.
►Never insert a damaged BATTERY into the DRIVEPACK.
►Check the BATTERY for visible damage, such as cracks or burn
marks, before each insertion.
►Make sure that the interfaces on the BATTERY are free of dirt
before using it.
You can check the charge level of the BATTERY at any time by pressing
the on/off button [D.5] once: The number of illuminated LEDs on the
charge level indicator [D.4] indicates the charge level. Each illumi-
nated LED corresponds to 20 % of the total charging capacity. When
the BATTERY is fully charged, all 5 LEDs light up.
1. Check the BATTERY for visible damage (visual
check).
2. Press the on/off button [D.5] on the BATTERY
once to turn on the BATTERY:
The LEDs on the charge level indicator [D.4]
next to the on/off button light up, indicating
the current charge level of the BATTERY.
If none of the LEDs on the charge level indicator light up after pressing the on/
off button, this indicates that the BATTERY is damaged.
If this happens, do not insert the BATTERY into the DRIVEPACK but contact an
authorized specialist.

27.2 Inserting the BATTERY in the DRIVEPACK

1. Hold the DRIVEPACK with one hand and the BATTERY with the other.
2. Position the BATTERY with the interface [D.2] facing forward toward the empty
battery holder [A.4] and align it so that the battery lock push button [D.1] is on
the same side as the corresponding opening on the DRIVEPACK.
124
US-English | Original instructions
DANGER
D.4
D.5