Installing Your New Appliance; Ventilation Of Appliance; Reversing The Door; Tools You Will Need - Candy CHICS 5182XWD Manuel D'utilisation

Service
•
Any electrical work required to do the
servicing of the appliance should be carried
out by qualified electrician or competent
person.
•
This product must be serviced by an
authorized Service Center, and only genuine
spare parts must be used.
1) If the appliance is Frost Free.
2) If the appliance contains freezer
compartment.
Note: Children aged from 3 to 8 years are
allowed to load and unload refrigerating
appliances.(This clause applies only to the EU
region.)

Installing your new appliance

Before using the appliance for the first time, you
should review the following tips.

Ventilation of appliance

In order to improve efficiency of the cooling
system and save energy, it is necessary to
maintain good ventilation around the appliance.
For this reason, sufficient clear space should be
available around the refrigerator.
It is advisable for there to be at least (50~70)mm
of space from the back to the wall, at least
100mm from its top,at last 100mm from its side
to the wall and a clear space in front to allow the
doors to open 135°. Please see the following
diagrams.
•
Note:
This appliance performs well within the
climate class from N to ST showed in the
table below.
It may not work properly if left at a
temperature above or below the indicated
range for a long period.
Climate class
SN
N
ST
T
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
•
Stand your appliance in a dry place to avoid
moisture damage.
•
Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away from
heat sources such as stoves, fires or heaters.
Leveling of appliance
•
For sufficient leveling and air circulating in
the lower rear section of the appliance, the
bottom feet may need to be adjusted.
•
You can adjust them manually using a
suitable spanner.
To allow the doors to self-close, tilt the top
backwards by about 10mm.

Reversing the door

Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied) to the
left side, if required.
Warning! When reversing the door, the appliance
must not be connected to the mains. Ensure that
the plug is removed from the mains socket.

Tools you will need

not provided
Thin-blade
8mm socket
screwdriver
wrench
Cross-shaped
Monkey wrench
screwdriver
Left Hinge Cover
≤10mm
Putty knife
8mm wrench
9