Reversing The Appliance Doors - Candy BI BM 193 NF Mode D'emploi

secured within the unit and that the
door(s) close and open properly. If there
is no resistance from the door seals
when opening the doors, then it is
probable that the appliance and/or
decor doors are not fitted properly.

Reversing the appliance doors

We recommend you seek the help of
another individual to support the doors
whilst performing this operation.
1. Carefully prise off the cover cap for the
top hinge and unscrew the screws fixing
the top hinge to the appliance, you
should support the upper door whilst
doing this.
2. Carefully remove the upper door and
place it somewhere safe. Note that there
are spacers between the door and the
hinge; note how many and their position.
3. Remove the central hinge by removing
the screws fixing it to the appliance;
support the lower door whilst doing this.
4. Remove the lower door and place it
somewhere safe, again noting the
position of any spacer pieces.
5. Swap the previous top hinge to the
opposite side at the bottom.
6. Refit the lower door using any spacers
and position the central hinge on the
door. After removing the cover caps, fix
the hinge securely to the appliance.
7. Swap the previous bottom hinge to the
opposite side at the top. Refit the upper
door and the "new" top hinge and fix
securely to the appliance.
8. Fit the central cover caps and top
hinge cover pieces in place to complete
the process.
9. Unscrew all four slider brackets from
the doors and swap them over to the
side furthest from the new hinge
positions, before the decor door is fitted.
Ensuring the door seals
correctly:
It is normal for the seal to
be compressed after the door has been
reversed. With the door closed, use a
hair dryer to expand the seal and fill the
gap between the door and the body of
the appliance.
Take care not to use the hair dryer too
close to the appliance, which could
damage the seal. A distance of
approximately 10cm should be adequate.
When completed, allow the seal and
door to cool before touching them. Once
done, the seal should remain in position.
30