Troubleshooting; Device Does Not Respond To Commands From The Remote Control; Cleaning / Maintenance; Cleaning & Maintenance - SilverCrest SFS 18 A1 Manuel D'utilisation Et Informations Sur Les Services

Troubleshooting

Device does not respond to commands
from the remote control

Check whether the correct device (A or B) was
selected on the remote control.

Check whether the remote control was programmed
with the correct code appropriate to your device.

Your device may not be compatible for programming
via the code list. In this case, programme the remote
control via the learning function (see page 71).

The batteries are low or empty. Please replace the
batteries with new batteries of the same type. Please
pay particular attention to the chapter "Inserting the
batteries" on page 69.

Cleaning / maintenance

It is necessary to repair the remote control if it has been
damaged in any way, for example, if the housing is
damaged, if liquid or objects have penetrated the remote
control or if it has been exposed to rain or moisture. Repairs
are also required if it is not working properly or has been
dropped. If smoke is produced, or there are any unusual
sounds or smells, remove the batteries immediately. In such
cases, the remote control should not be used until it has
been inspected by authorised service personnel. Only have
the device repaired by qualified personnel. Never open the
housing of the remote control. Only use a clean, dry cloth
for cleaning the remote control and never use any corrosive
liquids. Never try to open the housing of the remote control
as this would void your warranty.
SilverCrest SFS 18 A1
English - 73