Optional Tubular Clamp; Tubular Type Keys; Cutting Tok-Winkhaus Keys Tk23; Fichet Type Keys Fc6 And Fc120 - Errebi DAKAR-EXPRESS Notice D'utilisation

>>>
ENGLISH
1
Height no. 1, indicates that no cut should be made. Position
no. 2 indicates that a small cut should be made in the key. A
bigger cut is indicated by height no. 3. Height no. 4 indicates
the biggest cut in the key.
The key should be taken and the 6 positions marked shown
on the sketch below.
POSITION
INCLINATION
3.2.6 Cutting a MD13R key
Special position of the clamp.
3.2.7 Cutting a tesa key TS14 and TS12
Special position of the clamp. The TS14 key is clamped as shown
in the drawing below:
The TS12 key has the peculiarity that to machine the left-hand
side it has to be clamped like the TS14 key and to machine the
right-hand side it has to be clamped on the back of the clamp
as for the MD13R.

3.3 OPTIONAL TUBULAR CLAMP

This section explains the different models of keys that can be cut if
you purchase the tubular clamp (optional clamp, not supplied with
the standard DAKAR-EXPRESS machine):

3.3.1 Tubular type keys

Use the tracer point and milling cutter no. 8. Position the keys in the
centre of the " V ", with the guides to the right, so that they are
properly in place. Adjust the keys using the lights and always cut from
top to bottom, to avoid any bending in the tracer point. Remove the
flexibility from the tracer point with the X – Y locking. 1st speed.
3.3.2 Cutting tok-winkhaus keys TK23, TK24, TK25
& TK27
Use tool no. 15. Adjust two flat blank keys. Then place the key
with the teeth upwards in the correct position (as shown in
the drawing). The tip should be right in. Remove the flexibility
from the tracer point, with the machine switched on, insert the
tracer point right in one of the points. Lock the milling cutter
and the tracer point with the right-hand lever and make the
cut. 1st speed.
>>> 12
2 3 4
See figure 14
A B C D E
3 4 1 2 4
See figure15
See figure16
See figure 17
See figure 18
3.3.3 Fichet type keys FC6 & FC120
Use the tracer point and milling cutter no. 11. Properly adjust the
keys in the clamp, resting them on the bottom and pushing them
towards the front face of the clamp.
Position the milling cutter and the tracer point at about the same
height, remove the flexibility from the tracer point and lock the
milling cutter and the tracer point so that the milling cutter passes
over the clamp without touching it.
Having cut the two top sides, turn the keys taking care to remove
any burrs to ensure correct positioning and locking. 1st speed.
F
2
See figure 19