Maintenance And Storage; Technical Specifications - Lanaform Trimax Mode D'emploi

• Back and waist massage
EN
Place the massaging system on the sofa in a vertical position by pressing its base against the back of the chair and
sit down, pressing the part of the back and waist that you would like to massage against the appliance. If you feel
uncomfortable, place a thick piece of cloth between the massaging appliance and this part of your back and waist.
• Palm massage
The stimulation of certain points in the palm can alleviate stiffness felt in the neck and shoulders.

MAINTENANCE AND STORAGE

Clean the appliance before any use for an extended period of time. Switch the power supply interrupter to the off position
after using the TRIMAX appliance.
Cleaning:
• Verify that the interrupter is in the off position and that the plug has been removed before cleaning the appliance.
• Do not use a solvent to clean the appliance, as this may damage the leather and produce cracks in the plastic.
• In the event of an oil-based stain, clean with a cotton cloth soaked in detergent; then use a dry cloth to dry the
appliance. Clean the appliance with a clean cloth.
• The use of a humid cloth to clean the remote control and the area around the switch is forbidden. Use a soft, dry cloth.
• Avoid the transfer of any detergent into the ventilation slot located at the back of the appliance.
• Do not wash the unit with a cleaning brush or any hard object, as this may cause damage to the unit.
• Refrain from disassembling the appliance so as to avoid any risks.
Storage:
Unplug the appliance from the plug socket and leave it to cool down before storing it in its box or in a clean, dry place,
out of the reach of children. Do not wind the power supply lead around the unit, as this could damage and break the lead.
TROUBLESHOOTING
Malfunction
The appliance does not work when
the power supply is turned on
The appliance stops working after a
certain time

TECHNICAL SPECIFICATIONS

Voltage: 220 V—240V/50Hz
Consumption: 60 W
6
Cause
The power supply does not work
The power supply lead may be
damaged
The button does not work
The treatment time has been exceeded.
Solution
Check for the presence of
electricity.
Send the appliance to the
technical centre
Press the ON/OFF button; the
appliance will turn itself on
when you hear a «beep».
Restart the unit