Product Description; Control Panel - IKEA FINSMAKARE Manuel

ENGLISH

Product description

Control Panel

BUTTON FUNCTION
A =
Turns the motor on/off at speed one.
Speed
Turns the motor on at speed two / Activate charcoal filter alarm
Press and hold the button for approximately 2 seconds, with all the loads turned off (Motor+Lights),
B =
to turn the Activated Charcoal Filter alarm on. LED (A) flashes twice to confirm
Speed
To turn the alarm off, press the button again and hold for at least 2 seconds.The relevant LED
flashes once (A). Only for recirculation mode. (please refer to page 8)
Turns the Motor on at speed three / Reset alarm grease filter saturation
C =
Press and hold the button for approximately 2 seconds, with all the loads turned off
Speed
(Motor+Lights), to reset the grease filter saturation alarm. LED (A) flashes three times.
Turns the motor on at Booster speed.
D =
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically
Speed
to the speed that was set before. If it is activated with the motor turned off, it will switch to OFF at
the end of the time. To deactivate it, press button D or press button A
E =
Press briefly: Turns the lighting system on and off at maximum intensity.
Light
Press and hold to change the lighting intensity up or down.
A B C
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel
D E
9