Preparing For The Installation Of The Tv; Kd-85/75Xg85 , Kd-75Xg87 - Sony SU-WL450 Informations D'installation

Preparing for the installation
of the TV
Refer to the Setup Guide for stand installation.
KD-85/75XG85
KD-75XG87
1
Mark the installation location on
the wall.
Use masking tape, etc. (not supplied) to
mark the location of the TV near the
Base or Base Adaptor. Refer to the
following table.
Screen centre point
Length for
marking
Model Name
1,909 683 200
KD-85XG85
KD-75XG87
1,673 468 200
KD-75XG85
2
Remove the screws from the
rear of the TV.
,
(1,000)
(300)
Masking tape
Unit: mm
Screen
centre
dimension
251
107
− 9 (GB) −
3
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
5.
Note
Firmly secure the Attachment parts using screws.
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Be sure to store the used or unused parts in a safe
place for future use. Retain this manual for future
reference.
Standard mounting (2-a)
Screw (+PSW 6 x 50)
Belt
Slim mounting (2-b)
Note
You cannot use some of the terminals on the rear of
the TV when using this mounting style.
Screw (+PSW 6 x 20)
Belt
Pulley
Screw
(+PSW 6 x 20)
Spacer
(60 mm)
GB
Pulley
Spacer (20 mm)