Kd-65/55Xg87 , Kd-65/55Xg85 - Sony SU-WL450 Informations D'installation

KD-65/55XG87
KD-65/55XG85
1
Remove the screws from the
rear of the TV.
2
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
5.
Note
Firmly secure the Attachment parts using screws.
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Be sure to store the used or unused parts in a safe
place for future use. Retain this manual for future
reference.
Standard mounting (2-a)
Belt
Screw (+PSW 6 x 50)
,
Pulley
Screw
(+PSW 6 x 20)
Spacer
(60 mm)
− 11 (GB) −
Slim mounting (2-b)
Note
You cannot use some of the terminals on the rear of
the TV when using this mounting style.
Belt
Screw (+PSW 6 x 20)
3
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Refer to the Reference Guide supplied with
your TV.
Note
Subcontract the cable routing in the wall to a licensed
contractor.
Bundle the connecting cables to prevent stepping on
them before wall mounting.
Pulley
Spacer (20 mm)
GB