Philips GC 4800 Serie Manuel D'utilisation page 20

EnGlish
20
Problem
The iron does
not produce a
steam boost.
Water
droplets drip
onto the
fabric during
ironing.
Possible cause
You have used the
steam boost function
too often within a
very short period.
The iron is not hot
enough.
You have not closed
the cap of the filling
opening properly.
You have put an
additive in the water
tank.
The set temperature
is too low for steam
ironing.
You have used the
steam boost function
at a temperature
setting below 3.
Solution
Continue ironing in horizontal
position and wait a while before you
use the steam boost function again.
Set an ironing temperature at which
the steam boost function can be used
( 3 to MAX). Put the iron on its
heel and wait until the temperature
light has gone out before you use the
steam boost function.
Press the cap until you hear a click.
Rinse the water tank and do not put
any additive in the water tank.
Set a temperature of or 2 higher.
Set the temperature dial to a setting
between 3 and MAX.