Philips GC 4800 Serie Manuel D'utilisation page 19

Problem Possible cause
The iron is There is a connection
plugged in, but problem.
the soleplate
is cold.
The temperature dial
is set to MIN.
The iron does There is not enough
not produce water in the water
any steam. tank.
The steam control is
set to position 0.
The iron is not hot
enough and/or the
drip-stop function has
been activated.
phone number in the worldwide guarantee leaflet). If
there is no Consumer Care Centre in your country,
go to your local Philips dealer.
troubleshooting
If the appliance does not work or does not work
properly, first check the list below. If the problem
is not mentioned in this list, the appliance probably
has a defect. In that case we advise you to take the
appliance to your dealer or to an authorised Philips
service centre.
Solution
Check the mains cord, the plug and
the wall socket.
Set the temperature dial to the
required position.
Fill the water tank (see chapter
'Preparing for use', section 'Filling the
water tank').
Set the steam control to a position
between 1 and 6 (see chapter 'Using
the appliance', section 'Steam ironing').
Set an ironing temperature that is
suitable for steam ironing ( 2 to
MAX). Put the iron on its heel and
wait until the temperature light has
gone out before you start ironing.
EnGlish
19