Installation - hestan KDW24 Manuel D'installation

INSTALLATION

EN
Remove the polystyrene rack blocks. Position the appliance in the chosen installation position.
The sides and rear of the appliance can lie against kitchen units or walls. If the dishwasher
is installed next to a heat source, separate it with a heat insulating panel in order to prevent
overheating and malfunctions.
MAKE SURE THE DISHWASHER HAS BEEN CORRECTLY INSTALLED AND GROUNDED
BY A QUALIFIED ELECTRICIAN. THIS SAFETY REQUIREMENT MUST BE MET. IN CASE
OF DOUBT, CALL IN A QUALIFIED ELECTRICIAN. THE MANUFACTURER DECLINES ALL
RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE
FAILURE TO GROUND THE APPLIANCE OR FROM A DEFECTIVE GROUND CONNECTION.
BEFORE PROCEEDING WITH INSTALLATION, TURN OFF THE CIRCUIT BREAKER THAT
WILL SUPPLY THE APPLIANCE.
LEVELING LEVELING
Level the appliance using the adjustable feet on the bottom.
Use a level and adjust the feet until the dishwasher is perfectly level. Leveling is vital for ensuring
correct dishwasher operation.
Make sure to leave a gap of at least 1/8" [3mm] between the top of the dishwasher door and the
bottom surface of the countertop.
8
© 2022 Hestan Commercial Corporation
DURING INSTALLATION, TAKE CARE NOT TO INJURE YOURSELF
ON THE SHARP EDGES OF THE APPLIANCE.
BUILDING-IN A DISHWASHER BELOW A COOKTOP IS
ABSOLUTELY FORBIDDEN.