hestan KDW24 Manuel D'installation page 17

OVERLAY PANEL
4. Use a hammer and small punch, or a drill with
a suitable bit to make pilot holes at the points
marked on the panel. DO NOT DRILL TOO
DEEP!!
• To avoid drilling too deep, use of a drill stop is
recommended.
5. Using a T15 Torx driver,
remove and discard the 2 small
covers shown. With a Phillips
screwdriver, secure the door
hooks (B, C) with the 8 supplied
flat head screws (items F) at the
marked reference points.
6. Use the Phillips screwdriver to
secure the lower brackets (D, E)
with the 8 supplied round head
screws (item G) at the marked
reference points.
Note: The lower brackets are used
with the sliding configuration only.
MOUNTING HANDLE MOUNTING HANDLE
The KDW24-OV model is not supplied with a door
handle. Installation of customer's preferred handle
should be done according to instructions provided
with the handle and according to good assembly
practices.
The handle mounting screws must be countersunk
or recessed so they do not protrude above the
overlay panel surface.
(CONT.)
REMOVE COVER
B
E
G
D
F
C
© 2022 Hestan Commercial Corporation
EN
15