hestan KDW24 Manuel D'installation page 19

OVERLAY PANEL
ATTACH THE DOOR PANEL - FIXED DOOR CONFIGURATION ATTACH THE DOOR PANEL - FIXED DOOR CONFIGURATION
Remove 2 plastic plugs on the inner face of the dishwasher door. Close the door, and fit the
hooks into their slots on the dishwasher, slide the panel upward and hold in place by hand.
Carefully lower the door again.
REMOVE
2 PLUGS
• Adjust the fit of the panel as you
like (top edge of door flush), then
install 2 screws (item E) in the holes
where you removed the plastic
plugs. The panel is now fixed to the
dishwasher door. Check that the
door opens fully.
ADJUST DOOR SPRING TENSION ADJUST DOOR SPRING TENSION
With the door now attached,
check the operation by opening
and closing a few times. The door
should not fall open, or snap closed.
Adjust the spring tension with the
2 adjuster screws at the bottom of
each hinge mechanism.
Proceed to FINAL STEPS.
(CONT.)
▐
▼
FIXED CONFIGURATION
2x (left & right)
E
© 2022 Hestan Commercial Corporation
EN
17