hestan KDW24 Manuel D'installation page 11

INSTALLATION
ELECTRICAL AND WATER CONNECTIONS ELECTRICAL AND WATER CONNECTIONS
Install the dishwasher to allow ease of access to the electrical and water connections through the
adjacent cabinetry. These connections must never be behind the dishwasher. The inlet and drain
hoses can be pointed in any direction but make sure that they are not bent, crushed or too tight.
Tighten the ring nut after pointing the hose in the required direction.
The illustration below indicates the lengths of hoses and power cord for connection purposes.
A through hole with a diameter
of at least 2-1/4" [5.7 cm] is
required to pass the hoses and
power cord.
• Make sure there are no rough
edges that could damage the
power cord or hoses.
• If the dishwasher is installed
in a metal cabinet or
enclosure, protect the edge
of the through hole for the
hoses and power cord with a
grommet.
• Do not use extension cords
when making the electrical
connection as these do not
guarantee safety.
INSTALLING THE DISHWASHER IN A NARROW SPACE MAY BEND OR CRUSH THE POWER
CORD. TAKE GREAT CARE IN ORDER TO REDUCE THE POSSIBILITY OF DAMAGING THE
POWER CORD WHEN INSTALLING OR REMOVING THE APPLIANCE.
CONNECTING THE WATER SUPPLY CONNECTING THE WATER SUPPLY
PREVENTING THE RISK OF CLOGGING OR
DAMAGE:
IF THE PLUMBING IS NEW OR HAS NOT
BEEN USED FOR A LONG TIME, BEFORE
CONNECTING TO THE WATER SUPPLY,
CHECK THAT THE WATER IS CLEAR AND FREE
OF DEBRIS TO PREVENT DAMAGE TO THE
APPLIANCE. THE DISHWASHER MUST ALWAYS
BE CONNECTED TO THE WATER SYSTEM WITH
NEW HOSES. OLD OR USED HOSES MUST
NEVER BE RE-USED.
(CONT.)
FIRE HAZARD!
DO NOT COVER OR CRUSH THE CORD PLUG.
A = 47" [120 cm]
B = 59" [150 cm]
C = 63" [160 cm]
D = min. 16" [40 cm]
A
B
C
A
© 2022 Hestan Commercial Corporation
EN
D
9