hestan KDW24 Manuel D'installation page 12

INSTALLATION
CONNECTING TO A WATER VALVE CONNECTING TO A WATER VALVE
Connect the inlet hose to a threaded 3/4" water valve using
EN
the supplied filter. Firmly secure the hose by tightening its
ring nut with your hands; finish by tightening another 1/4
turn using a pair of plumbing pliers.
Note: A 3/8" x 3/4" brass adapter is also supplied to connect
to a 3/8" water line if needed.
The dishwasher can be filled with water at a temperature
of less than 140°F [60°C]. If the appliance is filled with hot
water, washing times will be reduced by about 20 minutes,
but efficiency will be slightly impaired.
• Recommended temperature: 120°F [49°C], max 140°F
[60°C].
• Recommended water pressure: 7-130 PSI [0.5 - 9 bar]. If
the pressure is too high, use a pressure reducer.
A rubber hose connected to a sink spray may burst if installed on the same pipes feeding the
dishwasher. If your sink is fitted with this accessory, remove the hose and plug the hole.
If the hose is cut, the dishwasher will not work, water will
leak and you may be injured. If the hose is too long, wind it
up neatly and place it behind the appliance. The cable
harness and electrical components must not come into
contact with the hydraulic system and the water inlet and
drain hoses.
When connecting the dishwasher drain hose to the sink make sure that the hose is not bent in
order to prevent cracks or breakages that could damage it.
10
© 2022 Hestan Commercial Corporation
(CONT.)
DO NOT CUT THE INLET HOSE
A