Final Steps - hestan KDW24 Manuel D'installation

FINAL STEPS

GASKETS GASKETS
Before securing the dishwasher to the cabinets, attach the gaskets
EN
to the sides.
1. Remove the adhesive band from the gasket (see Figure 1).
2. Fix the gasket to the dishwasher, inserting it in the seat on the
sides towards the front (see Figure 2).
- Make sure that the long side of the gasket, the one with the
holes for inserting the screws, is attached to the outside of
the dishwasher.
- The hole in the long side must match the holes in the
dishwasher. (see A in Figure 3)


Figure 2
3. Make sure the gaskets adhere perfectly to the dishwasher. Figure 4 shows the state of the
dishwasher after operations 1-3 are done.
FINAL INSTALLATION FINAL INSTALLATION
1. Install the dishwasher in the opening using caution to route the hoses behind the unit without
damaging or kinking them. Use a spirit level (B) to check the level the unit. Make sure to leave a
gap (C) of at least 1/8" [3mm] between the top of the dishwasher door and the surface above it
(usually the underside of the countertop).
18
© 2022 Hestan Commercial Corporation
Figure 3
INSTALLING THE DISHWASHER IN A NARROW SPACE MAY BEND
OR CRUSH THE POWER CORD AND HOSES. TAKE GREAT CARE IN
ORDER TO REDUCE THE POSSIBILITY OF DAMAGING THE POWER
CORD AND HOSES WHEN INSTALLING OR REMOVING THE
APPLIANCE.
Figure 1
Figure 4