hestan KDW24 Manuel D'installation page 18

OVERLAY PANEL
ATTACH THE DOOR PANEL - SLIDING DOOR CONFIGURATION ATTACH THE DOOR PANEL - SLIDING DOOR CONFIGURATION
Fit the hooks into their slots on the dishwasher, slide the panel upward, and hold in place by
EN
hand. Install the special shoulder screws (item H) into the brackets using a T20 Torx driver.
Carefully lower the door, checking that the door slides freely and that the bottom edge of the
door is not interfering with the toe-kick area at the base of the dishwasher.
• Make sure that the screw shank (H) fits
through the hole in the bracket as shown
above.
• Make sure the dishwasher door, complete
with panel, opens fully and slides freely.
• Vertical adjustments to the panel can be
made with the fine adjustment screw
located just above the special shoulder
screw (H).
ADJUST DOOR SPRING TENSION ADJUST DOOR SPRING TENSION
With the door now attached,
check the operation by opening
and closing a few times. The door
should not fall open, or snap closed.
Adjust the spring tension with the
2 adjuster screws at the bottom of
each hinge mechanism.
Proceed to
16
© 2022 Hestan Commercial Corporation
(CONT.)
TOE-KICK
AREA
SLIDING CONFIGURATION
FINAL STEPS.
2x (left & right)
VERT. FINE
ADJUST
H
H