Location And Installation - hestan KDW Serie Manuel D'installation

LOCATION AND INSTALLATION

UNPACKING AND PLACEMENT
Remove the outer carton and packing materials Do not remove the plastic film covering
the stainless-steel surfaces. This film protects the finish from scratches until the
appliance is installed in its final position.
The unit is heavy and should be handled with care. Use proper safety equipment, such as
gloves and 2 persons to move the appliance into position to avoid injury and to avoid
damage to the floor or the appliance itself.
DO NOT USE A HAND TRUCK OR DOLLY ON THE FRONT OR REAR
NOTICE
OF THE DISHWASHER. HANDLE AND MOVE FROM THE SIDES ONLY.
Do not lift or carry the appliance by the door or handle. This could damage the door hinges.
PREPARATION
Before moving the dishwasher, protect any finished flooring and secure the door closed
to prevent damage. DO NOT lift the dishwasher by the door handle.
Make sure that power can be provided to the location selected.
TOOLS
The following tools are needed for the installation of the dishwasher:
• Tape measure and straight edge or ruler
• Pencil
• Philips screw driver
• Level
• Plumbing pliers
• Hand or saber saw
• 13mm open-end or adjustable wrench
• File
• Drill and drill bit
• Safety gloves and goggles
STEPS FOR INSTALLATION
The following pages provide the necessary information for proper installation of the dishwasher
and are arranged as follows:
• Technical data.
• Installation cutout dimensions, required clearances and mounting instructions.
• Electrical requirements and connections.
• Leak inspection and testing.
©2018 Hestan Commercial Corporation
EN
3