LOCATION AND INSTALLATION
CAUTION
DURING INSTALLATION, TAKE CARE NOT TO INJURE YOURSELF
ON THE SHARP EDGES OF THE APPLIANCE.
Remove the polystyrene rack blocks. Position the appliance in the chosen installation
position. The sides and rear of the appliance can lie against kitchen units or walls.
If the dishwasher is installed next to a heat source, separate it
panel in order to prevent overheating and malfunctions.
BUILDING-IN A DISHWASHER BELOW A COOKTOP IS
ABSOLUTELY FORBIDDEN. A DISHWASHER CAN BE BUILT-IN
UNDERNEATH A CONVENTIONAL HOB PROVIDED THERE IS NO
BREAK IN THE KITCHEN WORKTOP, AND THE DISHWASHER
AND HOB ARE INSTALLED AND SECURED CORRECTLY, SO
THAT NO HAZARDS ARE GENERATED.
MAKE SURE THE DISHWASHER HAS BEEN CORRECTLY IN-
STALLED AND GROUNDED BY A QUALIFIED FITTER. THIS
SAFETY REQUIREMENT MUST BE MET. IN CASE OF DOUBT,
CALL IN A QUALIFIED FITTER. THE MANUFACTURER DE-
CLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS
OR PROPERTY RESULTING FROM THE FAILURE TO GROUND
THE APPLIANCE OR FROM A DEFECTIVE GROUND CON-
NECTION .
BEFORE PROCEEDING WITH INSTALLATION, DISCONNECT
THE MAINS POWER SUPPLY FROM THE WORK AREA.
LEVELING
Level the appliance using the adjustable feet on the bottom. Use an open-ended wrench
or socket to rotate the feet until the dishwasher is perfectly level. The rear foot can be
adjusted with a 8 mm wrench or socket. Use a level to be certain the dishwasher
is perfectly level. Leveling is vital for assuring correct dishwasher operation .
Make sure to leave a gap of at least 7/64" (3mm) between the top of the dishwasher
and the bottom surface of the countertop.
(continued)
with a heat insulating
©2018 Hestan Commercial Corporation
EN
5