hestan KDW Serie Manuel D'installation page 11

LOCATION AND INSTALLATION
CONNECTING TO A WASTE DISPOSAL UNIT WITH AN AIR GAP
MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE
DRAIN LINE AND AT LEAST 15-3/4" (400 mm) ABOVE THE FLOOR
ON WHICH THE DISHWASHER WILL BE INSTALLED.
1. Remove the cover of the waste disposal unit (A) .
2. Connect the dishwasher drain hose (B ) to the air gap (C) using the wide spring
clamp (D ) ; if necessary, cut the end of the dishwasher drain hose (E ) (do not cut the
corrugated section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2")
screw clamp*.
3. To connect the air gap (ref. C ) to the waste disposal unit inlet (F)
use a rubber union* (G ) with spring or screw clamps*
* Available from any plumbing store
C
D
CONNECTING TO THE AIR GAP WITHOUT A WASTE DISPOSAL UNIT
MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE
DRAIN LINE AND AT LEAST 15-3/4" (400 mm) ABOVE THE FLOOR
ON WHICH THE DISHWASHER WILL BE INSTALLED
1. Connect the dishwasher drain hose (ref. B ) to the air gap (C )using the wide spring
clamp (D) ; if necessary, cut the end of the dishwasher drain hose (E ) (do not cut the
corrugated section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2")
screw clamp*.
2. To connect the air gap (ref. C ) to the waste disposal unit inlet (F )
use a rubber union* (G ) with spring or screw clamps*
* Available from any plumbing store
B
C
A
H
G
H
B
G
F E
A
G
(continued)
E
D
©2018 Hestan Commercial Corporation
EN
9