hestan KDW Serie Manuel D'installation page 8

LOCATION AND INSTALLATION
ELECTRICAL AND WATER CONNECTIONS
Install the dishwasher to allow ease of access to the electrical and water connections
EN
through the adjacent cabinetry. These connections must never be behind the dishwasher.
The inlet and drain hoses can be pointed in all directions but make sure that they are not
bent, crushed or too tight. Tighten the ring nut after pointing the hoses in the required
direction.
The illustration below indicates the distances to maintain between the dishwasher and
the various connections.
FIRE HAZARD!
DO NOT COVER OR CRUSH THE CORD PLUG.
A through hole with a diameter of at least 5/32" (8mm) is required to pass the
hoses and power cord.
Make sure there are no rough edges that could damage the power cord or
hoses. If the dishwasher is installed in a metal unit protect the edge of the
through hole for the hoses and power cord with a gasket. Do not use extension
cords when making the electrical connection as these do not guarantee safety.
ATTENTION!
INSTALLING THE DISHWASHER IN A NARROW SPACE MAY BEND
OR CRUSH THE POWER CORD. TAKE GREAT CARE IN ORDER TO
REDUCE THE POSSIBILITY OF DAMAGING THE POWER CORD
WHEN INSTALLING OR REMOVING THE APPLIANCE.
6
©2018 Hestan Commercial Corporation
A = 47" / 1200mm
B = 59" / 1500mm
C = 63" / 1600mm
D = min. 16" / 400mm
(continued)
A
B
C
D