LOCATION AND INSTALLATION
CONNECTING TO A WASTE DISPOSAL WITHOUT AN AIR GAP
MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE
EN
DRAIN LINE AND AT LEAST 15-3/4" (400 mm) ABOVE THE FLOOR
ON WHICH THE DISHWASHER WILL BE INSTALLED.
1. Remove the cover of the waste disposal unit (A) .
2. Connect the dishwasher drain hose (B ) to the waste disposal unit inlet (C),
using the wide spring clamp (D).
* Available from any plumbing store
CONNECTING TO THE OUTLET
RATINGS ON THE NAME PLATE OF THE APPLIANCE, WHICH IS POSITIONED
ON THE INNER EDGE OF THE DOOR.
BY THE MANUFACTURER OR AN AUTHORIZED TECHNICIAN.
THIS APPLIANCE MUST BE GROUNDED. IN CASE OF A MALFUNCTION
OF FAULT, THE GROUND REDUCES THE RISK OF ELECTROCUTION BY
BY PROVIDING THE ELECTRICAL CURRENT WITH AN ALTERNATIVE,
LESS RESISTANT PATH. THIS APPLIANCE IS FITTED WITH A POWER CORD
CONTAINING A GROUND WIRE AND PLUG. FIT THE PLUG INTO A
SUITABLE OUTLET, INSTALLED AND GROUNDED IN COMPLIANCE WITH
LOCAL CODE.
BEFORE MAKING ELECTRICAL CONNECTIONS, DISCONNECT THE
MAIN POWER SUPPLY FROM THE WORK AREA.
WARNING AN INCORRECTLY CONNECTED GROUND WIRE MAY
GENERATE THE RISK OF ELECTROCUTION. IF IN DOUBT AS TO
THE CORRECT GROUNDING OF THE APPLIANCE, CALL IN A
QUALIFIED ELECTRICIAN OR THE TECHNICAL ASSISTANCE
SERVICE. DO NOT CHANGE THE PLUG ATTACHED TO THE
APPLIANCE.
OUTLET MUST BE OF THE SAME TYPE AND MUST CONFORM TO LOCAL
REGULATIONS GOVERNING ELECTRICAL APPLIANCES. NEVER REMOVE THE
PLUG BY PULLING ON THE CORD.
10
©2018 Hestan Commercial Corporation
B
CHECK THAT VOLTAGE AND FREQUENCY OF THE OUTLET MATCHES THE
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED
THE PLUG AT THE END OF THE POWER CORD AND THE CORRESPONDING
(continued)
A
D
C