hestan KDW Serie Manuel D'installation page 10

LOCATION AND INSTALLATION
CONNECTING TO A WATER TAP
Do not cut the inlet hose.
EN
If the hose is cut, the dishwasher will not work, water will leak and you may be
injured. If the hose is too long, wind it up neatly and place it behind the appliance.
The cable harness and electrical components must not come into contact with
the hydraulic system and the water inlet and drain hoses.
When connecting the dishwasher drain hose to the sink make sure that the
hose is not bent in order to prevent cracks or breakages that could damage it.
CONNECTING TO A "T" UNION FOR DRAINAGE
MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE
DRAIN LINE AND AT LEAST 400 mm (15-3/4") ABOVE THE FLOOR
ON WHICH THE DISHWASHER WILL BE INSTALLED.
Connect the dishwasher drain hose to the "T" union of the drain using a
1-1/2 to 2" (38 to 50 mm) screw clamp* if necessary, cut the end of the
dishwasher drain hose (DO NOT cut the corrugated section).
* Available from any plumbing store
8
©2018 Hestan Commercial Corporation
(continued)
(continued)