Important Instructions; Cleaning And Maintenance; Safety Cautions - Remington Flexibrush Steam CB4N Guide Rapide

ENGLISH
Due to the extreme heat capabilities of this styler, extra care should be taken when
using.
While heating and cooling, place on flat, smooth, heat-resistant surface. Only hold unit
at the end of the handle.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
Do not allow water from the reservoir cap to spill onto the handle.
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a
damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN
NOT IN USE
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their safety should give explicit
instructions or supervise the use of the appliance.

  5(0 ,)8 &%1B/LQGG 

IMPORTANT INSTRUCTIONS

CLEANING AND MAINTENANCE

SAFETY CAUTIONS

This product is not suitable for use in bath or shower.