Key Features; Important Instructions - Remington S1001CRK Mode D'emploi

ENGLISH
Thank you for buying your new Remington
Before use, please read these instructions carefully and keep them in a safe place for
future reference.
A. High heat setting 210 °C
B. Ready to use in 30 seconds
C. Ceramic coated plates for even heat
D. On-off switch
E. Automatic world wide voltage
F. Crackle effect nail varnish
G. Emery Board
H. Swivel cord
2 year guarantee
Before use, make sure hair is clean, dry and tangle-free.
Plug in the unit, the on-indicator will glow and the styler will be ready to use, in
approximately 30 seconds.
For extra protection and best results, section hair prior to straightening and spray with heat
protection spray. Always straighten the lower layers first.
Run the straightener through the entire length of the hair, without stopping.
Repeat only twice per section to prevent hair damage.
When used at 120V the heat up times & temperatures may vary.
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating, during use and cooling, place on a flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
110446_REM_IFU_S1001CRK_21L+.indd GB_1

KEY FEATURES

INSTRUCTIONS FOR USE

IMPORTANT INSTRUCTIONS

®
product.
1 1
24.06.11 16:29