Product Features - Remington Flexibrush Steam CB4N Guide Rapide

Masquer les pouces Voir aussi pour Flexibrush Steam CB4N:

Mode d'emploi (77 pages)

Table Des Matières

Table des Matières

Les langues disponibles

ENGLISH

Thank you for buying your new Remington

instructions carefully and keep them in a safe place for future reference.

(

)

Before use make sure hair is clean, dry and tangle free.

Remington Flexibrush can be used without steam. When steam is required ﬁrst ﬁll the water

reservoir.

Hold the unit in a vertical position with cap end down to prevent any spillage from any residual

water left in the cap.

Unscrew the reservoir and ﬁll with warm or cool water to the ﬁll line. Replace the cap with

the tong still held vertically with cap end down and twist gently into place.

Plug the unit into the mains and wait for about 5 minutes.

To activate steam, gently depress the cap. The unit is designed to release with one push, just

the right amount of steam required for a small section of hair.

Separate the section of hair to be curled and wrap around the hot barrel, winding up exactly

as you would use a roller.

Press reservoir cap to release the steam. Hold the Flexibrush in place for about 8-12 seconds

– then press the curl release button and carefully draw the unit away allowing hair to unwind

automatically. Let curls spring back and cool before combing.

To change the bristles, the unit must be unplugged and cool. Unscrew the Bristle Lock Guard

(B) and slide the bristles off the barrel. Taking the other set of bristles, gently glide each row

into a groove on the barrel and push into place. Screw the lock guard securely back into place.

5(0 ,)8 &%1B/LQGG