Hitachi WM 18DBL Instructions De Sécurité Et Mode D'emploi page 15

Electronic pulse mode, self drilling
screw mode (2) and drill mode
Electronic clutch mode
(reverse rotation)
Elapsed time after switching on
The tool may not return to the initial status from
the striking operation.
When the bit or socket is removed from the screw
or bolt while the switch is being pulled, the tool
may continue the striking operation.
To return to the initial status, turn off the switch
and then start the next operation.
Motor rotation speed does not decrease even when
the remaining battery power becomes low.
Since this tool adopts the constant-speed control,
the rotation speed is almost unchanged even when
the remaining amount of the battery becomes low.
This allows users to operate the tool efficiently until
the battery runs down. However, it is difficult to
know the remaining battery power from the
rotation speed and the tool may stop suddenly
during work.
Check the remaining battery power by pressing the
remaining battery indicator switch at times.
The tool stops automatically when the electronic
clutch is actuated.
Quiet screw tightening can be performed without
clutch sound generated by the mechanical type.
The tool stops automatically when the clutch is
actuated. If you continue to use the tool, turn off
the switch once and turn it on again. When the
tool does not operate even without load, the
remaining amount of the battery is low. In this case,
recharge the battery immediately.
3. Check the rotational direction
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the push button.
The L-side of the push button is pushed to turn
the bit counterclockwise. (See Fig. 7) (The
marks are provided on the body.)
R
Self drilling screw
mode (1)
Bolt mode
L
Electronic clutch mode
(regular rotation)
R
and
L
Push
CAUTION
The push button can not be switched while the
tool is turning. To switch the push button, stop
the tool, then set the push button.
4. Switch operation
When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool stops.
The rotational speed can be controlled by varying
the amount that the trigger switch is pulled. Speed
is low when the trigger switch is pulled slightly
and increases as the trigger switch is pulled more.
5. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
●
When using the hook, hang up the power tool
firmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
●
When carrying the power tool hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it hooked to your waist
belt, you will be injured.
●
Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
being used.
(1) Removing the hook.
Remove the screws fixing the hook with Philips
screw driver. (Fig. 8)
English
Push button
Push
Fig. 7
Screw
Hook
Fig. 8
15