LaserLiner ThermoXplorer Pro Mode D'emploi page 42

20.1
Area measurement / parameters
T1=19.3
Emissivity
Set emissivity for area 1 (T1).
Refer to Section 11.1.
A * symbol is shown
! next to the measured
value if values are de-
fined for measurement
points, lines or areas.
Set Ref
The temperature of area 1 (T1)
shows the reference temperature
(R). Refer to Section 10.2.
Area Type
Max Temp
Highest temperature within
the measurement area
Min Temp Lowest temperature within
the measurement area
Avg Temp Average temperature within
the measurement area
Area Move
Position
The position can be moved
with the arrow buttons
Size The size of the field can be
changed with the arrow buttons
Delete area
The area is deleted.
42
GB
T1=19.3
1
T1=19.3*
Settings
Emissivity 0.60
Set Ref No
Area Type Max Temp
Area Move Position
Delete area No
Settings
Emissivity 0.60
Set Ref Yes
Area Type Max Temp
Area Move Position
Delete area No
Settings
Emissivity 0.60
Set Ref No
Area Type Max Temp
Area Move Position
Delete area No
Settings
Emissivity 0.60
Set Ref No
Area Type Max Temp
Area Move Position
Delete area No
Settings
Emissivity 0.60
Set Ref No
Area Type Max Temp
Area Move Position
Delete area Yes
*