LaserLiner ThermoXplorer Pro Mode D'emploi page 41

18.3
To position horizontal lines
LH=17.2
19
Activate / deactivate vertical line measurement
Vertical line measurement works just like horizontal line measurement
(see chapter 18 ff.) and is used in the same manner.
Measurement
Level/Span
Setup
File
!
All added measurement points, lines and areas are removed by selecting „None".
20.0 Activate / deactivate area measurement
Up to three measuring surfaces can be set at one time. They can be assigned measure-
ment-specific parameters as well as the following properties: maximum temperature,
minimum temperature, average temperature.
Measurement
Level/Span
Setup
File
!
All added measurement points, lines and areas are removed by selecting „None".
LH=17.2 S1= 19.3 S1= 19.3
Measurement
Vertical
Type
Measurement
Add Area
Type
ThermoXplorer Pro
41
GB