LaserLiner ThermoXplorer Pro Mode D'emploi page 32

10.3
To set reference temperature
Measurement
Temp Range -20/350
Temp Unit °C
Amb Temp 25.8
Ref Type Off
Ref Temp 30.0
11.0 Measurement-specific settings: Setup
Before each use, check the settings for infrared measurement and adjust them to the
respective measuring situation to ensure accurate measurements. In doing so, please
pay particular attention to the general parameters with respect to emissivity coefficient,
distance to target and ambient conditions.
Measurement
Adjustment
Alarm / ISO
Measurement
Date / Time
Level/Span
System Setup
Setup
System Info
File Fact Default
11.1 Emissivity coefficient
The level of infrared emissions given off by everything depends on the specific material
and surface. This factor is determined by the emissivity coefficient (0.10 ... 1.0). For
accurate measurements, it is absolutely essential that the emissivity coefficient is set first.
The emissivity coefficient can either be custom set or selected based on the predefined
emissivity coefficients from the material list.
To set individual emissivity
Adjustment
Emissivity 0.96
Customize
T Correct 0.0
Distance 2.00
Humidity 60
TReflect Off
30.0
32
GB
Ref Temp
Spot 1
°C
Spot 2
Hotspot
°C
Coldspot
Area 1
°C
Area 2
Area 3
Off
Adjustment
Emissivity
Customize
T Correct
Distance
Humidity
TReflect
°C
! The input is increased or decreased
by 10 seconds by pressing and
holding the arrow buttons.
°C
The reference temperature
shows the temperature
difference between the set
reference temperature and
the measurement points,
lines and areas.
Example:
R = 30.0 °C
S1 = 35.9 °C
S1 is displayed with the
temperature difference
of 5.9 °C.
0.96
0.0 °C
2.00
60
Off
30.0