Yamaha VF150 Manuel De L'utilisateur page 71

Make sure that the trim rods retracts
completely during mooring. This pro-
tects the rods from marine growth and
corrosion, which could damage the
power trim and tilt mechanism.
1
1. Trim rod
Tilting up when using the tilt support lever
1. Move the remote control lever to the
neutral position.
[ECM00253]
ZMU06924
N
ZMU07034
N
ZMU06926
2. Push the " " (up) side of the power trim
and tilt switch to fully tilt the outboard
motor up.
UP
1. Power trim and tilt switch
1
UP
1. Power trim and tilt switch
3. Pull the tilt support lever toward you to
support the engine. WARNING! After
tilting the outboard motor, be sure to
support it with the tilt support knob or
tilt support lever. Otherwise the out-
board motor could fall back down
suddenly if oil in the power trim and tilt
unit or in the power tilt unit loses pres-
NOTICE: Do not use the
sure.
[EWM00263]
tilt support lever or knob when traile-
ring the boat. The outboard motor
could shake loose from the tilt support
and fall. If the motor cannot be
trailered in the normal running posi-
tion, use an additional support device
to secure it in the tilt position. For
Operation
1
ZMU07768
ZMU06986
65