Outboard Motor; Flushing Device; Installing Top Cowling - Yamaha VF150 Manuel De L'utilisateur

4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil lev-
el is not at the proper level or if it appears
milky or dirty.
1
1. Oil dipstick
2. Upper mark
3. Lower mark
EMU40412

Outboard motor

 Check that the outboard motor is mounted
properly and check the outboard motor
mounting bolts for looseness.
 Check the propeller for damage.
 Check for engine oil leaks.
EMU36494

Flushing device

Check that the flushing device's garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling. NOTICE: If the
garden hose connector is not properly
connected, cooling water can leak out and
the engine can overheat during operation.
[ECM01802]
2
1. Fitting
2. Garden hose connector
3
3. Flushing device
EMU40752
ZMU07753

Installing top cowling

1. Check the rubber seal for damage. If the
rubber seal is damaged, have it replaced
by a Yamaha dealer.
2
1. Rubber seal
2. Bottom cowling
2. Check that the rubber seal is seated all
the way around the bottom cowling.
3. Check that all of the cowling lock levers
are pulled outward.
4. Align the 3 protrusions on the top cowl-
ing with the corresponding holders on
the bottom cowling, and then place the
top cowling on the bottom cowling.
Operation
3 2 1
ZMU07754
1
ZMU07755
53