Connect The Speakers - Pioneer X-HM76 Mode D'emploi

> Before Start > Part Names

Connect the Speakers

1
2
a Speaker cable
> Install
RED RED
RED
a
a
> Initial Setup > Playback
3
RED
Advanced Setup | Firmware Update | Others
When connecting the speaker system for X-HM76, connect
the included speaker cables with ends with the red tubing
attached to the i jacks on the main unit and the speaker. If
connection is wrong, the phase reverses and this makes it
harder to output bass.
For XC-HM86, use the illustration as a reference to connect
your own speakers.
After inserting the speaker cables, tighten the terminals firmly
by turning to the right. Also make sure the exposed wires of the
speakers do not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers touch the rear
panel or the i and s wires touch each other, the protection
circuit may be activated and the power may turn off.
You can also connect a subwoofer with a built-in amplifier to
boost bass playback even more. Use a subwoofer cable for
connection.
E
N
9