Option Setting - Pioneer X-HM76 Mode D'emploi

> Before Start > Part Names
■ Wi-Fi Setup
Make Wi-Fi connection settings. ( P11)
This can be set only when "Wi-Fi" is selected in "Connection".
0 You can make Wi-Fi connection settings using a web browser on a computer. For details,
refer to "Web Setup" ( P35).
■ DHCP
"On" (Default Value): Auto configuration by DHCP
"Off": Manual configuration without DHCP
If selecting "Off", you must set "IP Address", "Subnet Mask", "Gateway", and "DNS Server"
manually.
■ IP Address
Displays/Sets the IP address.
■ Subnet Mask
Displays/Sets the subnet mask.
■ Gateway
Displays/Sets the gateway.
■ DNS Server
Displays/Sets the primary DNS server.
■ Proxy URL
Displays/Sets the proxy server URL.
■ Proxy Port
Displays/Sets the proxy server port number when you enter "Proxy URL".
■ Friendly Name
Change the device name for this unit which is shown on other devices connected to the
network to an easily recognized name. You can input up to 31 characters. For details on how
to enter text, refer to "Entering text" ( P31). After finishing input, press ENTER.
> Install > Initial Setup > Playback
■ AirPlay Password
You can set a password of up to 31 characters so that only registered users can use AirPlay.
For details on how to enter text, refer to "Entering text" ( P31). After finishing input, press
ENTER.
■ Network Check
You can check the network connection.

Option Setting

■ Power Off Setting
Auto Standby This setting places the unit on standby automatically after 20
minutes of inactivity without any audio input.
"On" : The unit will automatically enter standby mode.
"Off" (Default Value): The unit will not automatically enter
standby mode.
Network Standby When this feature is turned "On", you can turn on the power of the
unit via the network using an application that can control this unit.
0 Setting to "On" (Default Value) increases the power
consumption even when the unit is on standby.
0 "Network Standby", which suppresses power consumption,
may be disabled when the network connection is lost.
Bluetooth Wakeup This function wakes up the unit on standby by connecting a
BLUETOOTH enabled device.
"On": Use this function
"Off" (Default Value): Do not use this function
0 Setting to "On" increases the power consumption even when
the unit is on standby.
0 This setting is fixed to "Off" if "Bluetooth Setting" - "Auto Input
Change" is set to "Off".
■ Digital Filter
"Slow": Soft and fluid sound
"Sharp" (Default Value): Sound with more structure and firmness
Advanced Setup | Firmware Update | Others
E
N
33