Listening To The Fm/Am Radio; Tuning Automatically - Pioneer X-HM76 Mode D'emploi

> Before Start > Part Names

Listening To the FM/AM Radio

1
22
> Install > Initial Setup
a
d
b
c
d
f
e
f
g
h
i
> Playback
Advanced Setup | Firmware Update | Others

Tuning Automatically

1. Turn the unit on.
2. Repeatedly press TUNER to switch input between Tuner
FM and Tuner AM.
Tuner FM
AUTO
3. When you press TUNE i/j (b) on the remote controller,
automatic tuning starts, and searching stops when a
station is found. "Tuned Stereo" or "Tuned Mono" is
displayed when FM stations are being received.
When FM broadcasts are difficult to receive: Perform
the procedure for "Tuning Manually". If the "Tuning Mode" is
set to "Manual", the reception for FM broadcasts will be
monaural rather than stereo, irrespective of the sensitivity
of the reception.
When AM broadcasts are difficult to receive: Select the
mode with the best reception with noise cut mode. After
pressing MODE (e), press / (g) to select the mode with
the best reception (Mode1/Mode2/Mode3), then confirm.
Tuning Manually
You will need to change the initial settings. Press SETUP (i)
on the remote controller and select "Option Setting" -
"Tuner Setting" - "Tuning Mode" - "Manual" on the display
and confirm. Press SETUP (i) to finish the settings.
1. Turn the unit on.
2. Repeatedly press TUNER to switch input between Tuner
FM and Tuner AM.
87.50
MHz
E
N